Devcon Aluminium Liquid (F-2)

(0)

Aluminium filled pourable epoxy liquid for making moulds, patterns and fixings

Full Description →

Volume

Other

0.5 kg
10711
not available
€80.39
no0
Contact

Read more

RECOMMENDED APPLICATIONS

  • Used for making fine detailed duplicating masters 
  • Mould making for casting lightweight moulds 
  • Pattern making 
  • Making panographs 
  • Repairs to punch and die assemblies

CURE

A 12.7mm thick section of Devcon Epoxy will harden @ 24ºC in 4 hours. The material will be fully cured in 16 hours. 

SURFACE PREPARATION 

Proper surface preparation is essential to a successful application. The following procedures should be considered: 

  • All surfaces must be dry, clean and rough. 
  • If surface is oily or greasy, use Devcon Fast Cleaner 2000 Spray/Cleaner Blend 300 to degrease the surface. 
  • Remove all paint, rust and grime from the surface by abrasive blasting or other mechanical techniques. 
  • Aluminium repairs: Oxidation of aluminium surfaces will reduce the adhesion of an epoxy to a surface. This film must be removed before repairing the surface, by mechanical means such as grit-blasting or chemical means. 
  • Provide a “profile” on the metal surface by roughening the surface. This should be done ideally by grit blasting (8-40 mesh grit), or by grinding with a coarse wheel or abrasive disc pad. An abrasive disc may be used provided white metal is revealed. Do not ’feather edge’ epoxy materials. Epoxy material must be ’locked in’ by defined edges and a good 3 - 5 mil profile. 
  • Metal that has been handling sea water or other salt solutions should be grit blasted and high pressure water blasted and left overnight to allow any salts in the metal to ’sweat’ to the surface. Repeat blasting may be required to ’sweat out’ all the soluble salts. A test for chloride contamination should be performed prior to any epoxy application. The maximum soluble salts left on the substrate should be no more than 40 p.p.m. (parts per million). 
  • Chemical cleaning with Devcon Cleaner Blend 300 should follow all abrasive preparation. This will help to remove all traces of sandblasting, grit, oil, grease, dust or other foreign substances. 
  • Under cold working conditions, heating the repair area to 38ºC - 43º C immediately before applying any of Devcon’s Metal-filled Epoxies is recommended. This procedure dries off any moisture, contamination or solvents and assists the epoxy in achieving maximum adhesion to the substrate. 
  • Always try to make the repair as soon as possible after cleaning the substrate, to avoid oxidation or flash rusting. If this is not practical, a general application of FL-10 Primer will keep metal surfaces from flash rusting.

  • Comments
Loading comments...

Help is needed? Ask us!

The choice of materials for the maintenance of your equipment. Research of problems. Development of technical solutions.

Why Choose Us?

Qualified technical support.

Deliveries of goods to anywhere in the UK.

You can see price and a product's in-store online availability.